Hyundai Accent: Inspection

Lighting Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.

Lighting switch

HS : Head lamp switch(Short inside)

Dimmer And Passing Switch

HU : Head lamp high beam

HL : Head lamp low beam

HF : Head lamp passing switch

HS : Head lamp switch(Short inside)

Turn Signal Switch

Front Fog Lamp Switch

Wiper And Washer Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.

Wiper Switch (Intermittent)

INT 1 : Intermittent switch 1(Short inside)

INT 2 : Intermittent switch 2(Short inside)

B1 : B1(Short inside)

Wiper Switch

Washer Switch

Repair procedures

...

Removal

Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper (A) and lower (B) shrouds aft ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.5, 1.42 ~ 7.82) ...

Intake Air Temperature Sensor (IATS). Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Removal
Shift Lever Assembly Replacement 1. Remove the center console. (Refer to "interior (console)" in BD group) 2. Disconnec ...