Hyundai Accent: Removal
Wiper and Washer Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper (A) and lower (B) shrouds after
removing 3 screws.
|
| 3. |
Disconnect the connector(A). Release the lock of wiper switch
using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.
|
Multifunction Switch Assembly
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
| 3. |
Remove the steering column upper and lower shrouds after removing
3 screws.
|
| 4. |
Remove the clock spring.
(Refer to the RT group - "Airbag module")
|
| 5. |
Disconnect the lighting switch connector and wiper & washer switch
connector.
Remove the multifunction switch assembly (A) after loosening 2
mounting screws.
|
Flasher Unit
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the flasher unit (A) under the driver's lower crash pad
after disconnecting the connector and loosening the bolt.
|
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mu ...
Installation
Multifunction Switch
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the stee ...
See also:
Intake Air Temperature
Sensor (IATS). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between th ...
Camshaft Position Sensor
(CMPS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Thermostat. Troubleshooting
Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the thermostat gasket
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com