Hyundai Accent: Installation

Removal

1. Remove the mounting bolt and disconnect the horn connector, then remove the horn (A). ...

Adjustment

Operate the horn, and adjust the tone to a suitable level by turning the adjusting screw. After adjustment, apply a small amo ...

See also:

Projected Dimensions ( 4 Door )
Front side member tooling hole (Ø6.6) Side cover mounting hole (B/B’: Ø6.6/ Ø8.6) ...

Adjustment
Adjusting the control cable 1. Set room side AT lever(shift lever) and automatic transaxle side manual control lever to "N" position. 2. ...

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of ...