Hyundai Accent: TroubleshootingTroubleshooting
|
Symptom |
Possible cause |
Remedy |
|
Speedometer does not operate |
Cluster fuse (10A) is blown |
Check for short and replace fuse |
|
Speedometer faulty |
Check speedometer |
|
|
Vehicle speed sensor faulty |
Check vehicle speed sensor |
|
|
Wiring or ground faulty |
Repair if necessary |
|
|
Tachometer does not operate |
Cluster fuse (10A) is blown |
Check for short and replace fuse |
|
Tachometer faulty |
Check tachometer |
|
|
Wiring or ground faulty |
Repair if necessary |
|
|
Fuel gauge does not operate |
Cluster fuse (10A) is blown |
Check for short and replace fuse |
|
Fuel gauge faulty |
Check gauge |
|
|
Fuel sender faulty |
Check fuel sender |
|
|
Wiring or ground faulty |
Repair if necessary |
|
|
Low fuel warning lamp does not light up |
Cluster fuse (10A) is blown |
Check for short and replace fuse |
|
LED burned out |
Replace cluster |
|
|
Fuel sender faulty |
Check fuel sender |
|
|
Wiring or ground faulty |
Repair if necessary |
|
|
Engine coolant temperature lamp does not operate |
Cluster fuse (10A) is blown |
Check for short and replace fuse |
|
Engine coolant temperature lamp faulty |
Check lamp |
|
|
Engine coolant temperature sensor faulty |
Check sensor |
|
|
Oil pressure warning lamp does not light up |
Cluster fuse (10A) is blown |
Check for short and replace fuse |
|
Bulb burned out |
Replace bulb |
|
|
Oil pressure switch faulty |
Check switch |
|
|
Wiring or ground faulty |
Repair if necessary |
|
|
Parking brake warning lamp does not light up |
Cluster fuse (10A) is blown |
Check for short and replace fuse |
|
LED burned out |
Replace cluster |
|
|
Brake fluid level warning switch faulty |
Check switch |
|
|
Parking brake switch faulty |
Check switch |
|
|
Wiring or ground faulty |
Repair if necessary |
|
|
Open door warning lamp and trunk lid warning lamp do not light up |
Room lamp fuse (10A) is blown |
Check for short and replace fuse |
|
LED burned out |
Replace cluster |
|
|
Door switch faulty |
Check switch |
|
|
Wiring or ground faulty |
Repair if necessary |
|
|
Seat belt warning lamp does not light up |
Cluster fuse (10A) is blown |
Check for short and replace fuse |
|
LED burned out |
Replace cluster |
|
|
Seat belt switch faulty |
Check switch |
|
|
Wiring or ground faulty |
Repair if necessary |
Installation
Power Door LocksReplacement
Problems And Replacement Parts:
Problem
Part set
GDS required?
All keys have been lost
Blank key (4)
YES
An ...
Inspection
1.
Check the coil spring for crack and deformation.
2.
Check the coil spring pad for damage and deformation.
...
Replacement
The injector combustion seal should be replaced new one to
prevent leakage after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...