Hyundai Accent: Power Window Motor. Repair proceduresInspection
| 1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
| 2. |
Disconnect the connector from the motor.
|
| 3. |
Connect the motor terminals No.4 directly to battery voltage (12V)
and connect the motor terminals No.3 and No.6 directly to battery (-).
And then check that the motor operates smoothly. If the operation is
abnormal, replace the motor.
[Safety Power Window]
|
| 4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[General]
|
| 1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
| 2. |
Disconnect the 2P connector from the motor.
|
| 3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Components and Components LocationResetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is
blown, you must reset your sunroof system as follows:
1. Turn the ignition switch to the ON position and close the sun ...
Ignition switch position
LOCK
The steering wheel locks to protect against theft (if equipped). The ignition
key can be removed only in the LOCK position.
When turning the ignition switch to the LOCK position, push the k ...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...