Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Using a screwdriver or remover, remove the center fascia garnish
(A).
|
3. |
Disconnect defroster switch connector (A).
|
4. |
Using an ohmmeter, inspect the continuity between the terminals.
|
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is fo ...
Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve
upward.
2.
Install the water inlet fitting ( ...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...