1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the glove box.
(Refer to the BD group - "Crash pad")
|
3. |
Remove the DRL unit (A) after disconnecting the connector and
loosening the mounting nut.
|
Repair procedures
On-vehicle Inpection
•
Check that the battery cables are connected
to the correct terminals. ...
Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Installation
•
Install the component with the specified
torques.
•
...