1. |
Disconnect the negative (-) battery terminal.
|
2. |
Using a screwdriver or remover, remove the center fascia garnish
(A).
|
3. |
Disconnect Hazard lamp switch connector (A).
|
4. |
Remove the switch cover (A).
|
5. |
Remove the hazard lamp switch (A) after removing the air conditioner
switch and rear defogger switch.
|
Recommended SAE viscosity number
CAUTION
Always be sure to clean the area around any filler plug, drain plug, or
dipstick before checking or draining any lubricant. This is especially important
in dusty or sandy areas and when ...
Washer fluid
Checking the washer fluid level
The reservoir is translucent so that you can check the level with a quick visual
inspection.
Check the fluid level in the washer fluid reservoir and add fluid if ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and
IG ON.
...