Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the trunk lower trim.
(Refer to the BD group - " Trunk Lid")
|
| 3. |
Disconnect the rear combination lamp connector (A). Remove the
rear combination lamp assembly (B) after loosening 3 nuts.
|
| 4. |
Remove the bulb after turning in the counterclockwise direction.
A : Tail Lamp / Stop Lamp
B : Turn Signal Lamp
C : Back Up Lamp
D : Side marker
|
| 5. |
If necessary to remove the bulb, remove the bulb after pulling
the trim cover aside.
[Tail Lamp / Stop Lamp]
[Turn Signal Lamp]
[Back up Lamp]
[Side marker]
|
Installation
1.
Install the rear combination lamp assembly.
2.
Connect the rear combination lamp assembly connector.
3.
Conn ...
See also:
Troubleshooting
Troubleshooting
Symptom
Suspected area
Repairment
Pressing power switch does not turn on system
Radio receiver power source circuit
...
Cowl Top Cover. Repair procedures
Replacement
1.
Remove the wiper arm cap (B) and remove the nuts, then remove
wiper arm (A).
Tighening torque :
22.6 ~ 26.5 Nm (2.3 ~ ...
Adjustment
Clutch Release Cylinder
Air Bleeding Procedure
Use the specified fluid. Avoid mixing different brands
of fluid ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com