Hyundai Accent Manuals

Hyundai Accent: Removal - Repair procedures - Ignition Switch Assembly - Body Electrical SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Ignition Switch Assembly / Repair procedures / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column")
3.
Disconnect the ignition switch connector (B) and the key switch connector (A) from under the steering column.

4.
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin with key ACC.

Inspection
1. Disconnect the ignition switch connector (B) and key switch connector (A) from under the steering column. 2. Check for continui ...

Installation
1. Install the key lock cylinder. When assembling, the key must be inserted at ...

See also:

How vehicle audio works
FM radio reception AM and FM radio signals are broadcast from transmitter towers located around your city. They are intercepted by the radio antenna on your vehicle. This signal is then receive ...

Inspection
• Frequent inhalation of brake pad dust, regardless of material composition, could be hazardo ...

Starting the engine
WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, slippers, ski boots, etc.) may interfere with your ability to use the brake, accelerator pedal, a ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com