When heavy rear components such as suspension, fuel
tank, spare tire, tailgate and trunk lid are to be removed, place additional
weight in the luggage area before hoisting. When substantial weight
is removed from the rear of the vehicle, the center of gravity may change
and can cause the vehicle to tip forward on the hoist.
|
|
1. |
Place the lift blocks under the support points as
shown in the illustration.
|
2. |
Raise the hoist a few inches (centimeters) and rock
the vehicle to be sure it is firmly supported.
|
3. |
Raise the hoist to full height to inspect the lift
points for secure support.
|
Seat Heater Switch. Schematic Diagrams
Schematic Diagram
...
Repair procedures
Troubleshooting
Starter Circuit
The battery must be in good condition and fully charged.
1.
...
Removal
Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper (A) and lower (B) shrouds aft ...