Hyundai Accent: Electrical System
Hyundai Accent RB (2010-2018) Service Manual / General Information / Electrical System
| 1. |
Be sure to disconnect the battery cable from the
negative (-) terminal of the battery.
|
| 2. |
Never pull on the wires when disconnecting connectors.
|
| 3. |
Locking connectors will click when the connector
is secure.
|
| 4. |
Handle sensors and relays carefully. Be careful not
to drop them against other parts.
|
Replacement
Standard values, such as torques and certain adjustments,
must be strictly observed in the reassembly of all parts.
If removed, the following parts should always be replaced
with new ones ...
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or
tubing.
...
See also:
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Sunroof Motor. Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim. (Refer to the BD group - " Roof trim")
...
Front Disc Brake. Components and Components Location
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper body
4. Caliper carrier
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com