Hyundai Accent: Dimensions Projected
Hyundai Accent RB (2010-2018) Service Manual / General Information / Dimensions Projected
| 1. |
These are the dimensions measured when the measurement
points are projected from the vehicle's surface, and are the reference
dimensions used for used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable,
measure it by lengthening one of two probes as long as the different
value in height of the two surface.
|
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken
with a tracking gauge.
2.
When a measuring tape is used, check to be sure there
...
Measuring Actual Dimensions
1.
These dimensions indicate the actual linear distance
between measurement points, and are used as the reference dimensions
when a tracking gauge is used for measurem ...
See also:
Exhaust Manifold. Repair
procedures
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
Tightening torque ...
Back-up Lamp Switch. Description and Operation
Description
Back up lamp switch is pushed by the reverse lug sliding when select arm,
and switches the back up lamp.
...
Crankshaft Position Sensor
(CKPS). Troubleshooting
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS)
and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection
and ignition timing by using ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com