Hyundai Accent: Measuring Actual Dimensions
Hyundai Accent RB (2010-2018) Service Manual / General Information / Measuring Actual Dimensions
| 1. |
These dimensions indicate the actual linear distance
between measurement points, and are used as the reference dimensions
when a tracking gauge is used for measurement.
|
| 2. |
First adjust both probes to the same length (A=A')
before measurement.
|
Dimensions Projected
1.
These are the dimensions measured when the measurement
points are projected from the vehicle's surface, and are the reference
dimensions used for used for body ...
Measurement Point
Measurements should be taken at the center of the hole.
...
See also:
Engine Coolant Temperature
Sensor (ECTS). Description and Operation
Description
Engine Coolant Temperature Sensor (ECTS) is located in the
engine coolant passage of the cylinder head for detecting the engine coolant
temperature. The ECTS uses a thermistor th ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the crankshaft position sensor connector
...
Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the map lamp switch.
...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com