Symptoms
|
Possible Causes
|
Remedy
|
Coolant leakage
|
| •
|
From the thermostat gasket
|
|
Check the mounting bolts
|
| •
|
Check the torque of the mounting bolts
|
|
| •
|
Retighten the bolts and check leakage again.
|
|
Check the gasket for damage
|
| •
|
Check gasket or seal for damage
|
|
| •
|
Replace gaskets and reuse the thermostat.
|
|
Cooled excessively
|
| •
|
Low heater performance (cool air blowed-out)
|
| •
|
Thermogauge indicates 'LOW'
|
|
Visually check after removing the radiator cap.
|
| •
|
Insufficient coolant or leakage.
|
|
| •
|
After refilling coolant, recheck.
|
|
GDS check&Starting engine
|
| •
|
Check connection of the fan clutch or the
fan motor.
|
※ If the fan clutch is always connected, there will be
a noise at idle.
|
| •
|
Check the engine coolant sensor, wiring and
connectors.
|
| •
|
Replace the componants.
|
|
Remove the thermostat and inspect
|
| •
|
Check if there are dusts or chips in the
thermostat valve.
|
| •
|
Check adherence of the thermostat.
|
|
| •
|
Clean the thermostat valve and reuse the
thermostat.
|
| •
|
Replace the thermostat, if it doesn't work
properly.
|
|
Heated excessively
|
| •
|
Thermogauge indicates 'HI'
|
|
Visually check after removing the radiator cap.
|
| •
|
Insufficient coolant or leakage.
※ Be careful when removing a radiator cap
of the overheated vehicle.
|
| •
|
Check air in cooling system.
|
|
| •
|
After refilling coolant, recheck.
|
| •
|
Check the cylinder head gaskets for damage
and the tightening torque of the mounting bolts.
|
|
GDS check&Starting engine
|
| •
|
Check the fan motor performance as temperature
varies.
|
| •
|
Check if the fan clutch slips.
|
| •
|
Check the water pump adherence or impeller
damaged.
|
|
| •
|
Check the engine coolant sensor, wiring and
connectors.
|
| •
|
Check the fan motor, the relay and the connector.
|
| •
|
Replace the fan clutch, if it doesn't work
properly.
|
| •
|
Replace the water pump, if it doesn't work
properly.
|
|
Immerse the thermostat in boiling water and inspection.
|
| •
|
After removing the thermostat, check it works
properly.
|
※ Check the thermostat opens at the valve opening temperature.
|
| •
|
Replace the thermostat, if it doesn't work
properly.
|
|
See also:
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Replacement
ATF of 6 speed automatic transaxle doesn’t need to be replaced.
If the vehicle is used severely in business or personal use, ...
Oil And Filter Replacement
•
Prolonged and repeated contact with mineral
oil will result in the removal of natural fats ...
Hyundai Accent: Thermostat. Troubleshooting
Installation
