Hyundai Accent Manuals

Hyundai Accent: Removal - Oil Pan. Repair procedures - Lubrication System - Engine Mechanical SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Lubrication System / Oil Pan. Repair procedures / Removal

1.
Remove the under covers (A).
Tightening torque:
6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 7.9lb-ft)

2.
Drain engine oil.
3.
Using the SST(09215-3C000) and remove the oil pan.

•
Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow.
•
After tapping the SST with a plastic hammer along the direction of edge of the oil pan, remove it from the ladder frame. arrow around more than 2/3 edge of the oil pan, remove it from the ladder frame.
•
Do not turn over the SST abruptly without tapping. It be result in damage of the SST.

Oil Pan. Repair procedures
...

Installation
1. Install the oil pan. (1) Using a razor blade and gasket scraper, remove all the old packing material from the gasket surfaces. ...

See also:

Body Side Moldings. Repair procedures
Replacement Trunk Lid Garnish Replacement [Sedan] • When prying with a flat-tip ...

Inspection
Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin play (measu ...

Installation
Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com