Hyundai Accent: Disassembly
| 1. |
Disconnect the M-terminal (A) on the magnet switchassembly.
|
| 2. |
After loosening the 2 screws (A), detach the magnetswitch
assembly (B).
|
| 3. |
Loosen the through bolts (A).
|
| 4. |
Remove the rear bracket (A) and brush holderassembly
(B).
|
| 5. |
Remove the yoke (A).
|
| 6. |
Remove the packing (A), lever plate (B), lever (C)
and the armature (D).
|
| 7. |
Press the stopper (A) using a socket (B).
|
| 8. |
After removing the stop ring (A) using stopper pliers(B).
|
| 9. |
Remove the stop ring (B), stopper (A), overrunningclutch
(C) and armature (D).
|
| 10. |
Reassembly is the reverse of disassembly.
|
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
(-) terminal :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4l ...
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...
See also:
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken
with a tracking gauge.
2.
When a measuring tape is used, check to be sure there
...
Operating door locks from inside the vehicle
With the door lock button
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark (2) on the button will be visible.
To lock a door, push the door lock bu ...
Interior Trim. Repair procedures
Replacement
Door Scuff Trim Replacement
[Sedan]
•
Put on gloves to protect your ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com