Hyundai Accent: Cleaning
| 1. |
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will
damage the insulation wipe these parts with a cloth only.
|
| 2. |
Do not immerse the drive unit in cleaning solvent.
The overrun clutch is pre-lubricated at the factory
and sol-vent will wash lubrication from the clutch.
|
| 3. |
The drive unit may be cleaned with a brush moistened
with cleaning solvent and wiped dry with a cloth.
|
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...
Starter Relay. Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay(A).
3.
Using an ohmmeter, check t ...
See also:
Installation
•
Be sure to check the low pressure fuel hose
quick-connector (A) is completely connected to ...
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake/clutch fl ...
Removal
Handle the sensor with care.
1.
Remove the tire. (Refer to "Tire Removal")
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com