Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS). Repair procedures / Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).

3.	Disconnect the injector connector (A).

4.	Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Knock Sensor (KS). Repair procedures

...

Installation

• Install the component with the specified torques. • ...

See also:

Removal
Handle the sensor with care. 1. Remove the tire. (Refer to "Tire Removal") ...

Tightening Torques
Engine Control System Item kgf.m N.m lb-ft ECM installation bolt 1.0 ~ 1.2 9.8 ~ 11.8 7.2 ~ 8.7 ...

Components and Components Location
Component Location 1. Driver power window switch 2. Door lock switch 3. BCM (Body Control Module) 4. Front door lock actuator 5. Rear door lock actuator 6. I ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com