Hyundai Accent: Rail Pressure Sensor (RPS). Description and Operation

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

Installation

• Install the component with the specified torques. • ...

Rail Pressure Sensor (RPS). Specifications

Specification ...

See also:

Removal
1. Remove the front wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Cleaning
1. Make sure the ignition switch and all accessories are in the OFF position. 2. Disconnect the battery cables (negative first). ...

Troubleshooting
Troubleshooting Symptom Suspect Area Remedy Water leaks from sunroof Dirt accumulated in drain tube Clear dirt inside of drain ...