Hyundai Accent Manuals

Hyundai Accent: Removal - Rail Pressure Sensor (RPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS). Repair procedures / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Installation
• Install the component with the specified torques. • ...

See also:

Side Impact Sensor (SIS). Components and Components Location
Components ...

Sunvisor
Use the sunvisor to shield direct light through the front or side windows. To use a sunvisor, pull it downward. To use a sunvisor for a side window, pull it downward, unsnap it from the bracket ...

Electrical System
1. Be sure to disconnect the battery cable from the negative (-) terminal of the battery. 2. Never pull on the wires when disconnecting con ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com