1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the OCV connector.
|
3. |
Measure resistance between the OCV terminals 1 and
2.
|
4. |
Check that the resistance is within the specification.
|
Troubleshooting
Troubleshooting
Symptom
Possible cause
Remedy
Hard steering
Improper front wheel alignment
Excessive turning resistance of lower ar ...
Use approved window washer anti-freeze in system
To keep the water in the window washer system from freezing, add an approved
window washer anti-freeze solution in accordance with instructions on the container.
Window washer anti-freeze is avail ...
Repair procedures
Inspection
Front Door Lock Actuator
1.
Remove the front door trim.
(Refer to the Body group - Front door)
2.
Remove the front door ...