Hyundai Accent Manuals

Hyundai Accent: Inspection - Fuel Pump. Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pump. Repair procedures / Inspection

[Fuel pump]
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecting power(No.2) and ground(No.4)

Pin No.
 discription
1
 Fuel sender signal
2
 Fuel pump (+)
3
 Fuel sender ground
4
 Fuel pump (-)

[Fuel sender]
1.
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.

Pin No.
 discription
1
 Fuel sender signal
2
 Fuel pump (+)
3
 Fuel sender ground
4
 Fuel pump (-)

2.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position
 Resistance (Ω)
 Capacity (ℓ)
E
 197 ~ 203
 2.8
 1/2
 64.2 ~ 68.2
 22.3
F
 6 ~ 10
 41.8


Installation
1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2 ...

Fuel Filter. Repair procedures
Replacement 1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) an ...

See also:

Rear Wheel Speed Sensor. Components and Components Location
Components 1. Rear wheel speed sensor connector 2. Rear wheel speed sensor ...

Camshaft Position Sensor (CMPS). Troubleshooting
Wave Form ...

Replacement
1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the fro ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com