Hyundai Accent: Removal
| 1. |
Open the fuel filler door, and then remove the filler-neck
assembly mounting screws (A).
|
| 2. |
Disconnect the fuel filler hose (A) and tue vapor
hose (B).
|
| 3. |
Remove the filler-neck assembly from the vehicle
after removing the bracket mounting bolt (A).
|
Installation
1.
Installation is reverse of removal.
Filler-neck assembly
bracket installation nut :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...
See also:
Engine Coolant Temperature
Sensor (ECTS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Replacement
The injector combustion seal should be replaced new one to
prevent leakage after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
Removal
1.
Turn the ignition switch OFF and disconnect the negative
(-) battery cable.
2.
Disconnect the accelerator position sensor connector
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com