Hyundai Accent Manuals

Hyundai Accent: Removal - Delivery Pipe. Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Delivery Pipe. Repair procedures / Removal

In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold (Refer to "Intake And Exhaust System" in EM group).
4.
Disconnect the injector connectors (A) and the rail pressure sensor connector (B).
5.
Remove the high pressure fuel pipe (C).
6.
Remove the engine oil gauge.
7.
Remove the installation bolt (D), and then remove the delivery pipe and injector assembly from the engine.

Delivery Pipe. Repair procedures
...

Installation
• Do not use already used injector fixing clip again. ...

See also:

Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is seen. Make this adjustment before you start driving. WARNING - Rear visibility Do not place objects in the rear seat ...

Driver's and passenger's front air bag
Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger seating positions. The indications of the system's p ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS). Schematic Diagrams
Circuit Diagram ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com