1. Before closing the hood, check the following:
2. Return the support rod to its clip to prevent it from rattling.
3. Lower the hood until it is about 1 ft. (30 cm) above the closed position and let it drop. Make sure that it locks into place.
WARNING
Disassembly
Engine removal is required for this procedure. (Refer to
Engine and transaxle assembly removal in this group)
1.
M/T : Remove the fly wheel.
2.
...
Side Impact Sensor (SIS). Components and Components
Location
Components
...
Installation
1.
Connect the audio unit connectors and cable.
2.
Install the audio unit.
3.
Install the crash pad center fas ...