Hyundai Accent: Inspection
| 1. |
Inspect diaphragm spring wear which is in contact
with a concentric slave cylinder bearing.
|
| 2. |
Check the clutch cover and disc surface for wear
or cracks.
|
| 3. |
Check the clutch disc lining for slipping or oil
marks.
|
| 4. |
Measure the depth from a clutch lining surface to
a rivet. If the measured value is less than the specification below,
replace it.
|
Removal
1.
Remove the transaxle assembly. (Refer to "Manual
transaxle system" in MT group)
2.
Remove the clutch cover bolts. Be careful ...
Installation
If reinstalling used cover, the cover should be installed
with its clutch disc as a set.
1.
Re ...
See also:
ETC (Electronic Throttle
Control) System. Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Starter. Components and Components
Location
Components
1. Screw
2. Front bracket
3. Stop ring
4. Stopper
5. Overrun clutch
6. Lever
7. Lever plate
8. Lever packing
9. Magnet switch
10. Arma ...
Tire traction
Tire traction can be reduced if you drive on worn tires, tires that are improperly
inflated or on slippery road surfaces. Tires should be replaced when tread wear
indicators appear. To reduce the ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com