Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Clutch System / Clutch System / Clutch Master Cylinder. Repair procedures / Removal

•	Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

1.	Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer.

2.

Remove the clutch pedal mounting nuts (A-2ea).

Tightening torque:

12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

3.	Remove the battery and ECM. (Refer to "Manual transaxle system" in MT group)

4.	Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.

5.	Remove the clutch master cylinder by turning it clockwise (A).

Clutch Master Cylinder. Repair procedures

...

Installation

1. Installation is the reverse of removal. • ...

See also:

Washer fluid
Checking the washer fluid level The reservoir is translucent so that you can check the level with a quick visual inspection. Check the fluid level in the washer fluid reservoir and add fluid if ...

Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace ...

Operation Principle
The CVVT has the mechanism rotating the rotor vane with hydraulic force generated by the engine oil supplied to the advance or retard chamber in accordance with the CVVT oil control valve con ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com