Hyundai Accent Manuals

Hyundai Accent: Inspection - Clutch Pedal. Repair procedures - Clutch System - Clutch SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Clutch System / Clutch System / Clutch Pedal. Repair procedures / Inspection

Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin play (measured at the face of the pedal pad.)
Standard value
Stroke (A):
140 ± 0.3 mm (5.5118 ± 0.0118 in.)
Free play (B): 6 ~ 13 mm (0.2362 ~ 0.5118 in.)
Height (C): 173 mm (6.8110 in.)

Ignition Lock Switch Inspection
1.
Disconnect 2P-connector from a ignition lock switch.
2.
Disconnect the ignition lock switch. (if you can install a tester with the switch fixed, this step can be omissible)
3.
Check for continuity between terminals. (refer to the table below)
•
If there is difference between what tested and the table above, replace the ignition lock switch with a new one.
Pedal position
 Clutch switch
 Ignition lock
switch
Released
Pressed
(Continuity)
 Released (Open)
Fully pressed
Released (Open)
 Pressed
(Continuity)

Standard value
Full stroke (A): 12.0 ± 0.3mm (0.4724 ± 0.0118 in.)
ON-OFF point (B): 2.0 ± 0.3mm (0.0787 ± 0.0118 in)


Clutch Pedal. Repair procedures
...

Removal
• Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contac ...

See also:

Curtain Airbag (CAB) Module. Components and Components Location
Components ...

Rear Glass Defogger Printed Heater. Repair procedures
Inspection Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure ...

To set cruise control speed
1. Push the cruise ON-OFF button on the steering wheel to turn the system on. The CRUISE indicator light in the instrument cluster will illuminate. 2. Accelerate to the desired speed, which must ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com