Hyundai Accent Manuals

Hyundai Accent: Removal - Shift Lever. Repair procedures - Manual Transaxle Control System - Manual Transaxle System (M6CF1)Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Manual Transaxle System (M6CF1) / Manual Transaxle Control System / Shift Lever. Repair procedures / Removal

Shift Lever Assembly Replacement
1.
Remove the floor Interior console assembly.
(Refer to "Interior (Console)" in BD group)
2.
Remove the select cable snap pin (A) and the clip (B) from the select cable assembly.
3.
Remove the clip (A) from the shift cable assembly.
Set securely.

4.
Remove the shift lever assembly (B) after removing shift lever assembly installation bolts (A-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

5.
Installation is the reverse of removal.
•
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Shift Cable Replacement
1.
Remove the floor Interior console assembly.
(Refer to "Interior(Console)" in BD group)
2.
Remove the select cable snap pin (A) and the clip (B) from the select cable assembly.
3.
Remove the clip (A) from the shift cable assembly.
Set securely.

4.
Remove the retainer (A) and nuts (B-2ea).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Remove the pins (A).
6.
Remove the cable (B) from the cable bracket at manual transaxle assembly side.
7.
Remove the shift cable and select cable at cabin room.
Insert securely.
Marking must be shown after assembly.


Shift Lever. Repair procedures
...

Inspection
1. Check the select cable for proper operation and for damage. 2. Check the shift cable for proper operation and for damage. ...

See also:

Description and Operation
Description The Evaporative Emission Control System prevents fuel vapor stored in fuel tank from vaporizing into the atmosphere. When the fuel evaporates in the fuel tank, the vapor passes t ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pilla ...

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate continu ...

Hyundai Accent Manuals


В© 2011-2025 Copyright www.hamanual.com