Hyundai Accent: Disassembly and Reassembly

Hyundai Accent RB (2010-2018) Service Manual / Suspension System / Front Suspension System / Front Strut Assembly. Repair procedures / Disassembly and Reassembly

1.	Compress the coil spring with a strut spring compressor. Do not compress the spring more than necessary.

2.

Loosen the lock nut.

Tightening torque :

49.0 ~ 58.8N.m(5.0 ~ 6.0kgf.m, 36.2 ~ 43.4lb-ft)

3.	Disassemble the components of front strut assembly in sequence. (Refer to Front strut assembly components)

4.	Reassembly is the reverse of disassembly.

Replacement

1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Inspection

1. Check the components for damage or deformation. 2. Compress and extend the piston rod (A) and check that there is no abnormal resistance ...

See also:

Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...

Removal
1. Drain the brake fluid through the bleed plug (A). 2. Remove the clutch release cylinder assembly (C) after removing thd tube (B) ...

Navigation system
The navigation system ascertains the present position of your vehicle by using information from satellites and guides you to the place you assign as the destination. Detailed information for the na ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com