Hyundai Accent Manuals

Hyundai Accent: Installation - Front Impact Sensor (FIS). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / SRSCM / Front Impact Sensor (FIS). Repair procedures / Installation

•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
5.
Install the front bumper.
(Refer to the Body group - "Front bumper")
6.
Reconnect the battery negative cable.
7.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
• Removal of the airbag must be performed according to the precautions/ procedures described ...

Side Impact Sensor (SIS). Description and Operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to co ...

See also:

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Measuring Actual Dimensions
1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurem ...

If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1. Pull off the roa ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com