In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release the lever.
If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
CAUTION
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
WARNING Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on contact with the windshield and obscure your vision.
CAUTION
Tail lamp warning chime
If you turn the ignition switch to the OFF position with the tail lamps ON and
the driver's door in an open position, the warning chime will sound.
To stop the chime, perform one of the followi ...
Audio Unit. Components and Components Location
Components(PA710S)
Connector A
No
Terminal Description
Condition
Specified Condition
A1
Loudspeaker Rear Left+
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Lift the vehicle.
3.
Rem ...