Hyundai Accent: Removal
| 1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 2. |
Turn the steering wheel so that the front wheels can face straight
ahead.
|
| 3. |
Remove the driver airbag module mounting bolts (2EA).
|
| 4. |
Remove the wiring fixing clip (C), and then release the connector
locking pin to disconnect the driver airbag module connector (B).
|
| 5. |
Remove the steering wheel and steering wheel column shroud. (Refer
to the Steering System group - "Steering Column and Shaft")
|
| 6. |
Disconnect the clock spring connector, then remove the clock spring.
|
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
See also:
SS-B Solenoid Valve(ON/OFF). Description and Operation
Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed
at valve body.
...
Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the map lamp switch.
...
Installation
1.
Install the head lamp assembly after connecting the connector.
2.
Install the front bumper.
3.
Connect the n ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com