Hyundai Accent: Installation
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
| 3. |
Connect the clock spring harness connector to the clock spring.
|
| 4. |
Install the steering column shroud.
|
| 5. |
Set the center position by setting the marks between the clock
spring and the cover into line. Make an array the mark (▶◀) by turning
the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.
|
| 6. |
Install the steering wheel. (Refer to the Steering System group
- "Steering Column and Shaft")
|
| 7. |
Connect the driver airbag (DAB) module connector, and then install
the driver airbag (DAB) module on the steering wheel.
|
| 8. |
Secure driver airbag (DAB) with the new mounting bolts.
|
| 9. |
Connect the battery negative cable.
|
| 10. |
After installing the airbag, confirm proper system operation:
|
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
Passenger Airbag (PAB) Module. Description
and Operation
Description
The passenger airbag (PAB) is installed inside the crash pad and protects
the front passenger in the event of a frontal crash. The SRSCM determines if
and when to deploy the PAB. ...
See also:
Engine Coolant Temperature
Sensor (ECTS). Specifications
Specification
Temperature
Resistance (kΩ)
°C
°F
-40
-40
48.14
-20
-4
...
Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve
upward.
2.
Install the water inlet fitting ( ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com