Hyundai Accent Manuals

Hyundai Accent: Installation - SRS Control Module (SRSCM). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / SRS Control Module (SRSCM). Repair procedures / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Install the SRSCM with the SRSCM mounting nuts.
Tightening torque:
6.8 ~ 9.2 N.m (0.69 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)

Use new mounting nuts when replacing the SRSCM after a collision.
4.
Connect the SRSCM harness connector.
5.
Install the rear heating joint duct and floor console. (Refer to the Body group - "Console")
6.
Reconnect the battery negative cable.
7.
After installing the SRSCM, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Variant coding
After replacing the SRSCM with a new one, must be performed the “Variant Coding” procedure. 1. On ...

See also:

Removal
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Turn the steering wheel so that the ...

Sliding the sunroof
To open or close the sunroof (manual slide feature), pull or push the sunroof control lever backward or forward to the first detent position. To open the sunroof (autoslide feature), press the su ...

Components Location
Supplemental Restraint System Control Module (SRSCM) Driver Airbag (DAB) / Passenger Airbag (PAB) Side Airbag (SAB) Curtain Airbag (CA ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com