Replacement
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the steering column upper and lower shrouds (A) after removing
3 screws.
|
3. |
Disconnect the 6P connector (B) of the coil antenna and then remove
the coil antenna (A) after loosening the screw.
|
4. |
Installation is the reverse of removal procedure.
|
Wheel. Repair procedures
Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Components and Components Location
Component Location
1. Driver power window switch
2. Door lock switch
3. BCM (Body Control Module)
4. Front door lock actuator
5. Rear door lock actuator
6. I ...
Components and Components Location
Components
...