Hyundai Accent: Disassembly and Reassembly
Hyundai Accent RB (2010-2018) Service Manual / Suspension System / Front Suspension System / Front Strut Assembly. Repair
procedures / Disassembly and Reassembly
| 1. |
Compress the coil spring with a strut spring compressor. Do not
compress the spring more than necessary.
|
| 2. |
Loosen the lock nut.
|
| 3. |
Disassemble the components of front strut assembly in sequence.
(Refer to Front strut assembly components)
|
| 4. |
Reassembly is the reverse of disassembly.
|
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Inspection
1.
Check the components for damage or deformation.
2.
Compress and extend the piston rod (A) and check that there is
no abnormal resistance ...
See also:
Installation
•
Do not use already used injector fixing clip
again.
...
Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of
the pedal pad to the floor board) and the clutch pedal clevis pin play
(measu ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com