Hyundai Accent: General Service Information
Hyundai Accent RB (2010-2018) Service Manual / General Information / General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before
starting work.
The support rod must be inserted into the hole near
the edge of the hood whenever you inspect the engine compartment to
prevent the hood from falling and causing possible injury.
Make sure that the support rod has been released
prior to closing the hood. Always check to be sure the hood is firmly
latched before driving the vehicle.
|
Preparation Of Tools And Measuring Equipment
Be sure that all necessary tools and measuring equipment
are available starting work.
Meaning Of Symbols
There are five primary symbols used to complement illustrations.
These symbols indicate the part to apply such materials during service.
Symbol
Meaning
...
Special Tools
Use special tools when they are required.
...
See also:
Shift Lever. Components
and Components Location
Components
1. Shift lever knob & boot assembly
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...
Adjustment
ETC module learning
procedure
When installing new ETC module or re-installing it, ETC module
learning procedure must be performed.
1.
Hold the ignition k ...
Rear Torsion Beam Axle. Repair
procedures
Replacement
[Disc Type]
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com