Hyundai Accent: Injector. Description and Operation

Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is controlled by length of injection time. The ECM controls each injector by grounding the control circuit. When the ECM energizes the injector by grounding the control circuit, the circuit voltage should be low (theoretically 0V) and the fuel is injected. When the ECM de-energizes the injector by opening control circuit, the fuel injector is closed and circuit voltage should momentarily peak, and then settle at system voltage.

Installation

• Install the component with the specified torques. • ...

Injector. Specifications

Specification Item Specification Coil Resistance (Ω) 1.5 [20°C(68°F)] ...

See also:

Rear Glass Defogger Switch. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia garnish (A). ...

Components
[RH] 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. T ...

Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary. Also check all ignition wiring and components to be sure they are not cracked, worn or damaged in any way. ...