Hyundai Accent: Inspection
| 1. |
Check that the light operate according to the following timing
chart.
|
| 2. |
If the daytime running light is not operated well, inspect the
connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary,
and recheck the system.
If the terminals look OK, go to step 3.
|
| 3. |
Make these input tests at the connector
If any test indicates a problem, find and by using ETM correct
the cause, then recheck the system.
If all the input tests prove OK, the junction box must be faulty;
replace it.
|
Installation
1.
Install the DRL unit.
2.
Install the glove box.
...
Lighting System
...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Crash Pad. Components and Components
Location
Components
1. Main crash pad assembly
2. Side airvent duct [RH]
3. Side airvent duct [LH]
4. Cluster assembly
5. Cluster facia panel
6. Heater control unit
7. ...
Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
eng ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com