Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Canister Close Valve (CCV). Repair procedures / Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the CCV connector.

3.	Measure resistance between the CCV terminal 1 and 2.

4.

Check that the resistance is within the specification.

Specification: Refer to "Specification"

5.	Disconnect the vapor hose connected with the canister from the CCV.

6.	Connect a vacuum pump to the nipple.

7.	Ground the CCV control line and apply battery voltage to the CCV power supply line.

8.

Apply vacuum and check the valve operation.

Specification: Vacuum maintained

Canister Close Valve (CCV). Repair procedures

...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. D ...

See also:

Components and Components Location
Component Location 1. Driver power window switch 2. Door lock switch 3. BCM (Body Control Module) 4. Front door lock actuator 5. Rear door lock actuator 6. I ...

Antenna Coil. Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after removing 3 sc ...

Installation
Installation is in the reverse order of removal. Perform the following : • Adjust a shift cable. • Refill engine with engine oil. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com