Hyundai Accent Manuals

Hyundai Accent: Inspection - Clutch Cover And Disc. Repair procedures - Clutch System - Clutch SystemHyundai Accent: Inspection

1.
Inspect diaphragm spring wear which is in contact with a concentric slave cylinder bearing.
2.
Check the clutch cover and disc surface for wear or cracks.
3.
Check the clutch disc lining for slipping or oil marks.
4.
Measure the depth from a clutch lining surface to a rivet. If the measured value is less than the specification below, replace it.

Standard value
Clutch disc thickness(A)[when free] :
8.3 ± 0.3 mm (0.3268 ± 0.0118 in.)
Clutch disc rivet depth(B) : 1.1 mm (0.0433 in.)


Removal
1. Remove the transaxle assembly. (Refer to "Manual transaxle system" in MT group) 2. Remove the clutch cover bolts. Be careful ...

Installation
If reinstalling used cover, the cover should be installed with its clutch disc as a set. 1. Re ...

See also:

Front Strut Assembly. Components and Components Location
Components • Tighten with specifed torque at curb position of vehicle ...

Installation
1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2 ...

Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com