Hyundai Accent Manuals

Hyundai Accent: Installation - Side Impact Sensor (SIS). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Side Impact Sensor (SIS). Repair procedures / Installation

Pressure Side Impact Sensor
1.
Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A).
Tightening torque :
1.1 ~ 1.3 N.m (0.11 ~ 0.13 kgf.m, 0.81 ~ 0.96 lb-ft)

•
Use the specified screws only.
2.
Install the front door trim.
(Refer to the Body group - "Front door")
3.
Reconnect the battery negative cable.
4.
After installing the pressure side impact sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
•
You must comply with the specified tightening torques with the tool specified because Pressure – Side Impact Sensors (P-SIS) may be broken or POP-NUT may be rotated.
•
Problems may be occurred in the durability of P-SIS or impact sensing performance may be depreciated if POP-NUT is rotated.
•
The door module must not be transformed because SRSCM judges a impact through the pressure sensor in the door module.
Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor with the bolt (B) then connect the side impact sensor connector (A).
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)

2.
Install the center pillar trim.
(Refer to the Body group - "Interior tirm")
3.
Install the door scuff trim.
(Refer to the Body group - "Interior tirm")
4.
Insert the seat belt to the anchor pretensioner (A).

Make sure the lock pin is connected properly.
5.
Reconnect the battery negative cable.
6.
After installing the Side Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
Pressure Side Impact Sensor • Removal of the airbag must be performed according to the ...

Seat Belt Buckle Switch (BS). Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status ...

See also:

Sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control switch located on the overhead console. The sunroof can only be opened, closed, or tilted w ...

Components(2)
[5 Door] 1. Roof trim 2. Retainer 3. Sunvisor 4. Assist handle 5. Assist handle bracket ...

Checking tire inflation pressure
Check your tires once a month or more. Also, check the tire pressure of the spare tire. How to check Use a good quality gage to check tire pressure.You can not tell if your tires are properly inf ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com