Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Audio / Audio Remote Control. Repair procedures / Installation

1.	Reassemble the steering wheel remote control switch after connecting the connector.

2.	Reassemble the steering wheel.

3.

Reassemble the driver airbag module.

Make sure the audio remote control switch and the airbag module connectors are plugged in properly.

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group - "DAB and Clock spring ...

Troubleshooting

Troubleshooting Symptom Suspected area Repairment Pressing power switch does not turn on system Radio receiver power source circuit ...

See also:

Inspection
1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. W ...

Rear Body ( 5Door )
Side outer panel rear corner Tail gate hinge mounting hole (Ø14) Tail gate hinge mounting hole ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com