1. |
Reassemble the hands free switch after connecting the connector.
|
2. |
Reassemble the steering wheel.
|
3. |
Reassemble the driver airbag module.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and
IG ON.
...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Installation
1.
Install the rear combination lamp assembly.
2.
Connect the rear combination lamp assembly connector.
3.
Conn ...