Hyundai Accent Manuals

Hyundai Accent: Installation - Manifold Absolute Pressure Sensor (MAPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Manifold absolute pressure sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the manifold absolute pressure sensor con ...

Intake Air Temperature Sensor (IATS). Description and Operation
Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction o ...

See also:

Crankshaft Position Sensor (CKPS). Troubleshooting
Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using ...

System operation
Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed contro ...

Installation
1. Installation is the reverse of removal. • ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com