Hyundai Accent: Installation| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
| 3. |
Connect the clock spring harness connector to the clock spring.
|
| 4. |
Install the steering column shroud.
|
| 5. |
Set the center position by setting the marks between the clock
spring and the cover into line. Make an array the mark (▶◀) by turning
the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.
|
| 6. |
Install the steering wheel. (Refer to the Steering System group
- "Steering Column and Shaft")
|
| 7. |
Connect the driver airbag (DAB) module connector, and then install
the driver airbag (DAB) module on the steering wheel.
|
| 8. |
Secure driver airbag (DAB) with the new mounting bolts.
|
| 9. |
Connect the battery negative cable.
|
| 10. |
After installing the airbag, confirm proper system operation:
|
Inspection
Passenger Airbag (PAB) Module. Description
and OperationRear Seat Belt. Repair procedures
Replacement
Rear Seat Belt Replacement
[Sedan]
•
When installing the belt, make s ...
Replacement
Front Door Trim Replacement
•
Be careful not to scratch the door trim and other parts.
...
Special Service Tools
Special Service Tools
Tool (Number and Name)
Illustration
Use
09581-11000
Piston expander
Spreading the front disc ...