Hyundai Accent Manuals

Hyundai Accent: Installation - Seat Belt Pretensioner (BPT). Repair procedures - Seat Belt Pretensioner - Restraint (Depowered)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT). Repair procedures / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the seat belt pretensioner with mounting bolts (B, C).
Tightening torque [Bolt B]:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the seat belt pretensioner (BPT) connector (A).
5.
Install the upper anchor bolts.
Tightening torque:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
6.
Install the following parts.
(Refer to the Body group - "Interior trim")
A.
Center pillar trim
B.
Door scuff trim
7.
Install the lower anchor bolts.
Tightening torque:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
8.
Reconnect the battery negative cable.
9.
After installing the seat belt pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the lower anchor bolt. ...

Restraint (Advanced)
...

See also:

Disassembly and Reassembly
1. Compress the coil spring with a strut spring compressor. Do not compress the spring more than necessary. 2. Loosen the lock nut. ...

Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. 3. Check th ...

Component(2)
...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com