Hyundai Accent Manuals

Hyundai Accent: Installation - SRS Control Module (SRSCM). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / SRS Control Module (SRSCM). Repair procedures / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Install the SRSCM with the SRSCM mounting nuts.
Tightening torque:
6.8 ~ 9.2 N.m (0.69 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)

Use new mounting nuts when replacing the SRSCM after a collision.
4.
Connect the SRSCM harness connector.
5.
Install the rear heating joint duct and floor console. (Refer to the Body group - "Console")
6.
Reconnect the battery negative cable.
7.
After installing the SRSCM, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Variant coding
After replacing the SRSCM with a new one, must be performed the “Variant Coding” procedure. 1. On ...

See also:

Instrument panel fuse replacement
1. Turn the ignition switch and all other switches off. 2. Open the fuse panel cover. 3. Pull the suspected fuse straight out. Use the removal tool provided in the engine compartment fuse pane ...

To increase cruise control set speed
Follow either of these procedures: Push the RES+ switch and hold it. Your vehicle will accelerate. Release the switch at the speed you want. Push the RES+ switch and release it immediately. ...

ESC connector input/output
Connector Terminal Specification Remark No Description 29 IGNITION1(+) High level of wake up ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com